|





|
Svan 943B Sound Level Meter
Note:
This model is now discontinued
and has been replaced by the
SVAN 953

|
|
 |

OVERVIEW
The SVAN 943B is all digital, Type 2 sound level meter, acoustic dose
meter and analyser. It is intended to general acoustic measurements,
environmental noise monitoring, occupational health and safety monitoring.
Using computational power of its digital signal processor the SVAN 943B
can perform real time 1/1 & 1/3 octave analysis including statistical
calculations and real time FFT analysis. All weighting filters, required by
standards (A, C, Lin), are available with this instrument.
Three acoustic profiles allow parallel measurements with independently
defined filters and RMS detector time constants (Impulse, Fast and Slow).
Each profile provides significant number of results (Leq, Lmax, Lmin , LPeak,
SPL, SEL etc.). Advanced time history logging for each profile provides
complete information about measured signal in non-volatile 8 MB (or 48 MB
option) internal memory and can be easy downloaded to any PC using USB 1.1
interface and SvanPC software.
Thanks to replaceable standard four AA batteries and robust, lightweight
construction, the SVAN 943B can be used in hard environmental conditions
over whole working day.
Top

 | Noise measurements (SPL, Leq, SEL, Statistics, TaktMax, time
history) with Type 2 accuracy |
 | Three parallel independent profiles of the meter mode with time
history (simultaneous to frequency analysis) |
 | 8 MB or 48 MB (option) internal memory for logging more then one
week (six weeks) of the three 1 sec results (one result per profile)
|
 | Measurement range 27 dBA RMS - 130 dBA RMS in the SLM mode |
 | 1/1 octave real time analysis with time history (option) |
 | 1/3 octave real time analysis with time history (option) |
 | FFT real time analysis (option) |
 | Acoustic dose meter function (option) |
 | Easy in use |
 | USB 1.1 interface (real time PC "front end" application supported)
|
 | Integration time programmable up to 24 h |
 | Standard four AA batteries (operational time > 12 h with alkaline
batteries) |
 | Hand held, light weight and robust case (only ca 600 grams including
batteries) |
Top

| SOUND LEVEL METER |
| Standards |
Type 2: IEC 651, IEC 804 and IEC 61672-1 |
| Results |
SPL, L eq , SEL, L den , L tm3 , L tm5 , statistics- L n (L 1 -L
99 ), L Max , L Min , L Peak , Time History
Three profiles measure simultaneously with independent set of
filters and detector times |
| Weighting Filters |
A, C and Lin (Type 1: IEC 651, IEC 804 and IEC 61672-1) |
| RMS Detector |
Digital True RMS detector with Peak detection, resolution
0.1 dB,
Time Constants: Slow, Fast, Impulse |
| SOUND ANALYSER (OPTION) |
| 1/1 octave* |
Real time analysis with spectra logging down to 2 ms
step
10 filters with centre frequencies from 31.5 Hz to 16 kHz (IEC 1261)
|
| 1/3 octave* |
Real time analysis with spectra logging down to 2 ms step
30 filters with centre frequencies from 25 Hz to 20 kHz (IEC 1261)
|
| FFT* |
Real time analysis |
| Dose meter* |
Acoustic dose (8 h) for q = 3,4 or 5 (selectable) |
| * EACH OPTION PARALLEL TO METER
MODE |
| BASIC DATA |
| Input |
Input IEPE interface with TNC connector |
| Microphones |
SV MI17, 1/4" Electret Microphone with built in IEPE
preamplifier TNC connector
SV MI17_1, 1/4" Electret Microphone with built in IEPE preamplifier
LEMO connector (option) |
| Measurement Range |
27 dBA RMS - 130 dBA RMS in SLM Mode
50 dBA RMS - 140 dBA RMS in Dose Meter Mode (option) |
| Dynamic Range |
100 dB, 20 bits A/D converter |
| Resolution |
0.1 dB |
| Frequency Range |
20 Hz - 20 kHz (input microphone dependent) |
| Sampling Rate |
48 kHz |
| Display |
LCD 97 x 32 pixels plus icons with backlighting |
| Memory |
8 MB or 48 MB (option) non-volatile flash type |
| Interface |
USB 1.1 (real time PC "front end" application supported),
analogue output AC 1 V Peak |
| Power Supply |
 | 4 x AA batteries operation time > 12 h (alkaline batteries)
|
 | With external battery operation time > 24 h (optional SA 17A
pack )
|
 | External power supply 6 - 24 V DC (1.5 W)
USB interface 5V @ 150 mA
|
|
| Environmental Conditions |
Temperature -10 oC to 50oC
Humidity up to 90 % RH, non condensed
|
| Dimensions |
280 x 82 x 42 mm (with microphone and preamplifier) |
| Weight |
Approx. 0.6 kg with battery |
Top

 |
Main result one channel view |
 |
1/1 octave spectrum |
 |
1/3 octave spectrum |

Top

|